Cisco 3750 - Catalyst EMI Switch, Руководство по установке оборудования

Страница: 182 / 230

Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
C-12
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Would you like to enter the initial configuration dialog? [yes/no]:
yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Step 2 Enter a host name for the switch, and press Return .
On a command switch, the host name is limited to 28 characters; on a member
switch to 31 characters. Do not use
-n , where n is a number, as the last character
in a host name for any switch.
Enter host name [Switch]: host_name
Step 3 Enter an enable secret password, and press Return .
The password can be from 1 to 25 alphanumeric characters, can start with a
number, is case sensitive, allows spaces, but ignores leading spaces. The secret
password is encrypted and the enable password is in plain text.
Enter enable secret: secret_password
Step 4 Enter an enable password, and press Return .
Enter enable password: enable_password
Step 5
Enter a virtual terminal (Telnet) password, and press Return .
The password can be from 1 to 25 alphanumeric characters, is case sensitive,
allows spaces, but ignores leading spaces.
Enter virtual terminal password: terminal-password
Step 6
(Optional) Configure Simple Network Management Protocol (SNMP) by
responding to the prompts. You can also configure SNMP later through the CLI
or CMS interface. To configure SNMP later type
no .
Configure SNMP Network Management? [no]: no