SERVICE MANUAL
–
Post eVolve Smart
9 - OPTIONAL DEVICES
CIRCONTROL, S.A.
–
Innovació, 3
–
08232
–
Viladecavalls (Barcelona)
Tel.: +34 937 362 940
–
Fax: +34 937 362 941
47
Web: www.circontrol.com
–
E-mail:
9
OPTIONAL DEVICES
This section describes in detail how to setup and replace quickly any device that can be
found inside the Charge Point. The devices described here are optional for the Charge
Point and may not be found in all the equipment:
•
Locking system (4, 5)
•
Plug shutter (8, 9)
•
Type MIX 4 plugs TM4 (11, 12)
•
RCD Type B self-reclosing (19 + 20)
•
RCD Type B (20)
•
Surge protection (21,23)
•
Anti-vandal doors
•
Anti-vandal key (31)
9.1
LOCKING SYSTEM (4,5)
Connector locking system is what blocks the connector in the Charge Point when a
charging transaction is ongoing.
Charging transaction starts when a user that has been authorized (through the RFID)
plugs the EV connector in the Charge Point.
The charging transaction continues even if the EV passes to state B (for example when
the battery of the EV is full) therefore, the locking system remains active.
Charging transaction finishes when the user that has started the charging transaction
identifies itself again in order to stop transaction. In Plug&Charge identification method
case, the charge transaction finishes when the charge transaction is stopped from the
EV.
There are two types of looking system, the monostable and by-stable systems. The
difference between them is the perception of the position of the locking mechanism. The
monostable system only knows if the locking mechanism is in the right position when it
is activated and the by-stable system knows if the locking mechanism is in the right
position on both cases, activated and deactivated.
