Installation
2-15
3930 Service Delivery Switch
Hardware Installation and Start-up Manual
009-3223-001 Standard Revision E
Copyright
©
2012-2014 Ciena
®
Corporation
January 2014
Ethernet Cables
The following ports on the 3930 use Ethernet cables and have standard
RJ-45 jacks:
•
MGMT 10/100 Port
•
Console Port
•
10/100/1000 Mbps ports — these copper ports are located on the far left
of the front of the chassis. These are ports 1 to 4 in the system and are
combo ports. The combo ports have both a copper and an SFP optic
version for the same port. Both ports can be cabled, however only one of
the copper/optic ports will be active at any time. The use of copper or
optical for Ports 1 to 4 is controlled through the software.
Ciena requires the use of Cat 5 STP cables or better for the Management and
copper ports. These interfaces are classified as intra-building only. The cable
shield must be terminated at both ends.
To install an Ethernet cable, insert the connector into the port on the device
until you hear a clicking sound. Insert the tail end of the cable into the port on
the terminating device.
Initial Configuration
Two different methods can be used to assign an IP address to the device:
•
using a DHCP server to automatically assign an IP address
(recommended)
•
configuring the IP address manually.
Both methods are accomplished through the CLI and are not described in this
document. See
“Turning Up the System” on page 3-1
Note:
If the device has not been assigned an IP address other than the
default IP address (either manually or through a DHCP server)
communication can only take place through the local management port.
Initial IP address configuration must therefore be done through the local
management port.
CAUTION:
Use caution when setting an IP address or subnet mask, the new value
takes effect immediately. If information is set that is inconsistent with network
settings, communication with the device may no longer be possible. If all other
troubleshooting methods have been exhausted, recovery may be possible using the
Reset button
.
Содержание 170-3930-900
Страница 103: ......
