Ciena 170-3930-900, Руководство по установке и запуску оборудования

Страница: 26 / 104

2-10 Installation
3930 Service Delivery Switch Hardware Installation and Start-up Manual
009-3223-001 Standard Revision E
Copyright
©
2012-2014 Ciena
®
Corporation January 2014
The installation procedure is the same for both SFP and SFP+ optics.
However, ensure that the installed optic matches the capability of the port and
that the optic is supported by the system. The list of supported SFPs is
documented in
Packet Networking Transceivers Reference (009-2011-602).
Unsupported optics may not function.
Once installed, the port has LED indications. See “LED Overview” on page 5-1
for more information.
For additional information see:
• “To Install a Pluggable Optic” on page 2-26
• “To Remove a Pluggable Optic” on page 2-27
Cable Installation and Guidelines
This guide assumes that the site's data cables have been properly installed in
a centrally wired distribution configuration. When installing fiber optic cables
and other network cabling, always have them installed and tested by a
technician who is certified by the Electronics Industry Association/
Telecommunications Industry Association (EIA/TIA). This ensures a quality
installation and presents one less variable to consider when troubleshooting.
When installing cable, Do:
• Use more cable than required, leaving some slack.
• Test each section of the network as it is installed. Even in new installations,
problems may occur that will be difficult to isolate later.
• When using shielded cables, ensure that the cable is terminated to
Ground at both ends
• Cover cables with cable protectors if it is necessary to run cables across
the floor.
• Label both ends of all cables.
• Use cable ties or Velcro tie wraps to secure cables. If staples are used,
they must be hand installed or use a depth stop.
• Use cable hangers and J-hooks.
WARNING: All electrical connections are intended for indoor use only.