Chyron infinit! series, Руководство по эксплуатации

Страница: 922 / 978

CHYRON Corporation
Total Motion Control 23-26 Revision D
&DSWXUH&
Once Video In has been enabled, a video clip can be cap-
tured. The
Capture
function operates just like the
Record and Stop buttons on a tape recorder. When the
Capture
function is enabled, the incoming video is tem-
porarily saved to the disk space that was allotted in the
Capture Limit window. When the
Capture
function is
disabled, the process stops. After the capture, the Start
point, End point and Loops can be set, and the clip can be
recorded to a SCSI Express drive as a Chyron Motion
File (CMF). Depending on the situation, Steps 2 and 3
can be reversed in order.
NOTE
Each time a Capture is executed on
the same drive, it overwrites the
previous Capture. To preserve a
Capture, it must be recorded to a
Chyron Motion File (CMF), or it will be
erased by the following Capture.
There can be only one capture file on
a system at any time, even though the
system may be equipped with more
than one SCSI Express drive.
To execute a Capture:
[ ] 1. If the system is equipped with CLYPS buffers,
select a Capture Type as follows. Otherwise,
skip to Step 2.
To set Capture Type:
• Highlight the Type: field, then press the
SPACE BAR
or click on the field to toggle
through the following choices: Chyron
Motion file (CMF)
;
JPEG Video
;
JPEG
Key and JPEG Video with Key .
[ ] 2. Turn on the output of the video source. For
example, this can mean turning on a camera, or
pressing
>
(Forward) on a DDR.