Chyron infinit! series, Руководство по эксплуатации

Страница: 740 / 978

CHYRON Corporation
Font Create Utility 18-8 Revision D
)RQW6L]H
Font Size refers to the height, in scanlines, of the tallest
character of the font. The tallest character in any Stan-
dard or International Font is “
Å
”, as shown in Figure 18-
5. All other characters in the font are, to varying degrees,
smaller than this character.
To set Font Size:
• In the
FONT SIZE
field, enter the selected Font Size
from 10 to 1000 using the Address Keypad, then
press or cursor to the next field.
Figure 18-5. Tallest Character in Font Set
The total size of the new Machine Font must take into
account both the Font Size and the Edge Size as follows:
• [Font Size + (2 X Edge Size)] must be less than or
equal to 1000.
For example: If you are converting an edgeless font, the
maximum Font Size can be
1000
. If you are converting a
bordered font with Edge Size = 10 , the value entered in
the Font Size field can be no larger than
[1000 - (2 X
Edge Size)] = 980 .
If a number below 10 is entered, the Font Size defaults to
10
. If a number between
1001
and
2000
is entered, the font
does convert, but it probably cannot be displayed on screen.
Å
098
The
Å
character would be entered in the
field as 098/0. The number CHR. ID
6160
below the Character ID Number
indicates the width of the character