Christie D4K35, Руководство по установке

Страница: 37 / 66

Section 3: Connect Devices to the Projector
D4K35 Setup Guide 3-5
020-100855-02 Rev. 1 (09-2014)
3.3 Connect Devices to the GPIO Port
The GPIO port is a 37-pin D-sub connector (female) located on the PIB3G input panel and provides 8 input
and 7 output signals for connecting external devices to the projector. To configure the pins on the connector,
tap
Menu > Administrator Setup > GPIO Setup .
As shown below, each available pairing of pins (+/–) is defined as either an input or output . Four inputs and
three outputs have already been predefined. Configure a pin as an input if you want the projector to respond to
an incoming signal, or as an output if you want an external device to respond to the projector.
Inputs Positive Negative Description
GPIN #1 Pin 1 Pin 20 3-D L/R Input Reference
GPIN #2 Pin 2 Pin 21 3-D L/R Display Reference
GPIN #3 Pin 3 Pin 22 Reserved
GPIN #4 Pin 4 Pin 23 Reserved
GPIN #5 Pin 5 Pin 24 Input
GPIN #6 Pin 6 Pin 25 Input
GPIN #7 Pin 7 Pin 26 Input
GPIN #8 Pin 8 Pin 27 Input
Outputs Positive Negative Description
GPOUT #1 Pin 9 Pin 28 External 3-D L/R Output Reference
GPOUT #2 Pin 10 Pin 29 Reserved
GPOUT #3 Pin 11 Pin 30 Reserved
GPOUT #4 Pin 12 Pin 31 Output
GPOUT #5 Pin 13 Pin 32 Output
GPOUT #6 Pin 14 Pin 33 Output
GPOUT #7 Pin 15 Pin 34 Output
PROJ_GOOD Pin 16 Pin 35 Projector Good
Figure 3-4 Admin: GPIO Setup Window and GPIO Port Location on Projector