Christie D4K35, Руководство по установке

Страница: 39 / 66

Section 3: Connect Devices to the Projector
D4K35 Setup Guide 3-7
020-100855-02 Rev. 1 (09-2014)
3.4 Connect Devices to the 3D Connector
The 3D connector is a 15-pin D-sub connector (female) located on the PIB3G Board. The following table lists
the control functions available through the 3D connector.
PIN SIGNAL NAME DIRECTION DESCRIPTION
1 +12V Out Power to 3D device. Maximum 1A (total between both
+12V pins).
2 GND / Ground
3 GND / Ground
4 RS232_RX In Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
5 RS232_TX Out Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
6 CONN_ Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
7 CO Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
8 3D_INPUT_REF In 3D L/R Input Reference (P)
(Voltage Limit: 1.4VDC to 12VDC)
9 +12V Out Power to 3D system. Maximum 1A (Total between both
+12V pins)
10 3D_INPUT_REFRERENCE- In 3D L/R Input Reference (N)
(Voltage limit: 1.4VDC to 12VDC)
11 3D_DISPLAY_RE In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
12 3D_DISPLAY_REFERENCE- In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
13 CONN_3D_MODE- Out 3D mode state from projector. From projector GPO
emitter. Compatible with current projector GPIO
requirements and restrictions. (24VDC max, 50mA
max)
14 CONN_SYNC- Out SYNC from projector. From projector GPO emitter.
Compatible with current projector GPIO requirements
and restrictions. (24DC max, 50mA max)
15 Not connected