Christie D4K35, Руководство по установке

Страница: 16 / 66

2-4 D4K35 Setup Guide
020-100855-02 Rev. 1 (09-2014)
Section 2: Installation and Setup
• 3D: Connects the projector to 3D products, such as MasterImage or Real D for polarizing and de-ghosting
3D content during projection.
ICP Faceplate Connections
The ICP board provides the image processing electronics for the projector. The ICP faceplate includes a
number of LEDs that are only functional when the projector is in full power mode.
• REGEN: (Regulators Enabled) Indicates the presence of the internal regulator enable signal. When illumi-
nated BLUE the internal regulators are enabled. When OFF, not enabled.
• SOFTST: (Software State) Indicates the state of the software application. When OFF, in a Fail state (0).
When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
• OSST: (Operating System State) Indicates the state of the operating system. When OFF, in a Fail state (0).
When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
• FMTST: (FMT FPGA State) Indicates the configured state of the FMT FPGA. When RED, unable to con-
figure FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main
application.
• ICPST: (ICP FPGA State) Indicates the configured state of the ICP FPGA. When RED, unable to configure
FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main applica-
tion.
• Port A / Port B: Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, active source present.
Touch Panel Controller (TPC)
The TPC is a touch-sensitive screen that you use to control the projector. It is mounted on the rear of the
projector and you can use the flexible connection to adjust the viewing angle. In general, the TPC provides
users with a means for monitoring operation and status of the projector. You typically use the TPC to turn the
lamp on or off, select an input device, and view status information.
You can install the TPC on a wall near the projector, or you can use the optional extension cable to control the
projector from a maximum distance of 100 feet.
Lamp Power Supply (LPS)
The Lamp Power Supply (LPS) (P/N 129-003104-XX) is an external component for the D4K35 projector. To
connect it to the projector, you use a twisted-pair high power lamp cable assembly, a RS-232 serial cable and
an Interlock (Lamp Enable) cable. You can install the LPS in the optional rack stand with the projector.
The LPS provides DC power for 2.0, 3.0, 4.5 and 6.0kW lamps. A breaker on the side of the LPS acts as a
power switch, and provides protection against over-current conditions of 50A or more. If a fault occurs or
excessive voltage is detected, the breaker automatically switches OFF to prevent damage.
The LPS includes two AC power outlets that you can use to power projector electronics or an approved
extraction unit. Do not use these outlets to power other devices. The outlets must be wired accordingly for the
local region.