Christie D4K35, Руководство по установке

Страница: 59 / 66

D4K35 Setup Guide 7-1
020-100855-02 Rev. 1 (09-2014)
7 Troubleshooting
This section provides information and procedures for resolving common projector issues. If you cannot resolve
a projector issue, contact a Christie accredited service technician.
7.1 Projector Does Not Power ON
• Check the wall circuit breaker to see if it is ON. If there is a prob-
lem with the wall circuit breaker, have a certified electrician inves-
tigate any electrical problem.
• Check the status of the LEDs on the rear corners of the projector.
( Figure 7-1 ). If there is no activity, see #3.
• Verify power by looking through the rear, right side grill. One
LED should be present in the upper right. This indicates the LVPS
has power. Another LED should be seen in the lower left indicat-
ing Main input. (
Figure 7-2 )
• On the TPC, verify in the Operational Status region of the Main
panel that there is no failure with PIB3G communication (PIB Status).
7.2 Lamp Does Not Ignite
• Tap Menu > Advanced Setup > Lamp History and verify the number of hours the lamp has operated.
Replace a lamp nearing the end of its operational life
• Tap Menu > Status and then Interlocks in the left pane. Check and correct all interlock failures.
• Tap Menu > Status and then All Alarms in the left pane. If a ballast communication error has occurred,
restart the projector and turn the lamp on.
• Tap Menu > Status and then Temperatures in the left pane. Verify if the DMD temperatures are too high. If
the temperatures are too high, cool the projector. Ensure the projector is properly ventilated, the air filters are
not blocked, and the liquid cooling reservoir has coolant.
Figure 7-1 Projector Status LEDs
Figure 7-2 View Power Status LEDs