Christie D4K35, Руководство по установке

Страница: 15 / 66

Section 2: Installation and Setup
D4K35 Setup Guide 2-3
020-100855-02 Rev. 1 (09-2014)
LED Status Indicators
Provide information about the status of the projector. See Section 5.3 Using the Touch Panel Controller (TPC)
for information about projector status.
Motorized Auxiliary Lens Mount (MALM)
An optional auxiliary lens mount can be installed adjacent to the primary lens mount to provide motorized
positioning of a 1.25x Anamorphic lens or a 1.26 Wide Converter lens in front of the primary lens. The Wide
Converter lens “zooms” the image from flat to scope image formats. The Anamorphic lens horizontally
spreads the image back into its wider 2.39:1 “scope” image and is most typically used on larger screen sizes.
Projection Lens
A variety of lenses can be used with the D4K35.
RS-422 Connector
Connects the motorized lens mount to the projector.
Security Locks
Prevents unauthorized access to projector components.
Shroud
Covers the motorized lens mount assembly. Remove the shroud to install a lens, a MALM, or 3D hardware.
Input Panel
Connects the projector to external devices. You use these faceplates to connect devices.
• PIB3G (Projector Intelligence Board) Faceplate Connections:
• 10Base-T/100Base-TX Ethernet: Connects the projector to a network.
• GPIO: Connects the projector to external Input and output devices. See 3.3 Connect Devices to the GPIO
Port for GPIO pinouts.
• DVI-A / DVI-B: Connects the projector to video and graphics sources. These are single-link ports for sin-
gle-link cables and connectors.
• 3G-SDI-A/3G-SDI-B: Connect a variety of high-definition sources to these SMPTE 292M/425 bit serial
standard interface BNCs. The connectors can be used together to deliver Dual Link HD-SDI following the
SMPTE 372M standard. Also supports quad link 4K sources (refer to supported inputs),with each connec-
tor input a quarter’s image at 2K resolution in SDI format.
• SCCI: A Simple Contact Closure Interface (SCCI) port that uses a simple dry contact closure to turn the
lamp on or off or to open or close the douser. See 3.2 Connect Devices to the SCCI Port for SCCI pinouts.
• RS232 ICP: Connects a projector to a computer for direct DLP communication.
• RS232 PIB3G: Connects the projector to Christie accessories or third-party automation equipment.
• Emergency Start: Starts the projector, turns the lamp on, and opens the douser when the Touch Panel
Controller is unavailable or disconnected. Press and hold this button, to close the douser and turn the lamp
off; the power remains on.
• Reset: Resets the projectors electronics. After the projector restarts, the projector returns to the standby
mode.