SVX8016 IP PBX System User Guide
陈泽科技有限公司
- 56 -
www.stephen-tele.com
RTP Start:
Specify the start port for RTP protocol. Default is 10000.
RTP End:
Specify the end port for RTP protocol. Default is 2000.
Save:
Save all the changes.
Cancel:
Discard all changes.
Activate:
Submit the changes to the system to take effect.
3.9.3.
Options
Click “General” menu, and “Options” submenu, the “options settings” page will appear.
Max Extension Len:
Define the maximum digits of the extensions’ number. The setting also effect to queue/ring
group number’s length.
Extension Base:
The start line of the extension numbers.
Tone zone:
Define the default tone zone.
Default Settings for New Extensions:
The features enabled here will affect all new created extensions.
Pound Passthrough:
Tick to enable the FXS port dial # as part of the dialed number. Be aware that you cannot dial
“#” as sending digit. For example, dialed string “12345#” will not be considered as number
12345 but “12345#”
Digitmap List:
Digit map is used to define the dial pattern, tell device what kind number is acceptable.
FXO Setting:
Input volume:
Affect the microphone’s volume.
Output volume:
Affect the speaker’s volume.
Busycount:
Device will sent out the busy signal if the amount of busy tone detected by the device is equal
to a bigger than the count.
FXS Setting:
Input volume:
Affect the microphone’s volume.
Output volume:
Affect the speaker’s volume.
Second Dial:
Tick to enable the second dial function of FXS ports.
Second Dial Prefix:
Set the second dial prefix of FXS ports.
