SVX8016 IP PBX System User Guide
陈泽科技有限公司
- 5 -
www.stephen-tele.com
RJ45-DB9 RS232 cable
1
Power Cable
1
Quick installation guide
1
2.3.
Ensure you have the following
One computer with Ethernet network interface
One analog telephone
2.4.
Front Panel
The front panel consists of several lights and ports:
Eth0
Eth0 connector is RJ-45 port used for connected with the public internet. The lights on the up corner of the port is
used to indicates the connection status, the port is connected correctly if yellow light is lit and the flash green light indicate
that there are data in transmission.
Eth1
4 LAN connectors are RJ-45 port used for unit configuration via the PC, unit LAN networking, and VoIP
capability. The lights on the up corner of the LAN port is used to indicates the connection status, LAN is
connected correctly if yellow light is lit and the flash green light indicate that there are data in transmission.
Console
An RS232 connector, used to access the CLI interface of the SVX8016.
Slot0/Slot1
Indicates the usage of the extensions. The light is lit when the extension is ringing or off-hook.
GSM
Indicates the usage of the GSM trunk. The light is lit when the GSM trunk is occupied.
Status
The flash status light indicates that the system is in the booting process. The light turns to solid green when
the system is successfully booted.
CF card slot
You will need a CF in order to use CDR and voicemail functionality.
Caution:
Power off the device before plug in the CF card, otherwise, the device may be damaged.
2.5.
Back Panel
Power
The power connector for connecting with the AC power, with a power switch beside. The power range is
100~240V AC, 50/60 Hz
GSM1/GSM2
The antenna connector of the GSM card.
Extension
The “Extension” connectors are RJ-11 ports used for connecting phones and other analog devices.
Line
The “Line” connectors are RJ-11 ports used for connecting incoming telephone lines.
