WK2 OFF-ROAD FRONT BUMPER
INSTALL INSTRUCTIONS
TABLE OF CONTENTS
REVISION B
29 AUGUST 2022
PAGE
of
26
40
59
BUMPER
Bumper Fascia Trimming for Bumper Mount [C]
1.
Mark out the Bumper Mount [C] top clearance on the
bumper. For the S-Limited Summit ~20mm x 10mm of
clearance is required from the pre existing cuts.
2. Using a 10mm drill piece, drill a hole to help trim
marking out area.
60
BUMPER
Bumper Fascia Trimming for Winch Cradle
1.
Mark out and trim the centre of the Bumper Fascia to
give clearance to the winch rope; cutting equally
about the centreline.
2. Dress all trimmed edges using a smooth file.
NOTE: Check the clearance from the Winch drum diameter. More or less
cutting may be required.
2017+ S-Limited/Summit Bumper shown.
BUMPER FASCIA TRIMMING COMPLETE
58
BUMPER
Bumper Fascia Trimming (Stage 3)
1.
Using the already trimmed Bumper Fascia as a guide,
mark the lines shown in the image.
2. Reassemble grille insert back into trimmed surround.
3. Dress all trimmed edges using a smooth file.
NOTE: Leave at least 10mm of material on the bottom portion.
2017+ S-Limited/Summit Bumper shown.
(centreline)
2017+ S-Limited/Summit Bumper shown.
