WK2 OFF-ROAD FRONT BUMPER
INSTALL INSTRUCTIONS
TABLE OF CONTENTS
REVISION B
29 AUGUST 2022
PAGE of
9
40
2
Detach Fender Flare Fasteners
1. Remove (1) M6 Bolt on each side, (drivers &
passengers).
2. Remove (2) Plastic Rivets with punch tool on each
side, (drivers & passengers).
3. Remove (2) plastic push fasteners on each side,
(drivers & passengers).
NOTE: It might be easier to turn the wheel so that it points inwards.
1
Remove Lower Fascia
1. Remove the lower fascia and set aside. Refer to the
Owners Manual for basic instructions.
NOTE: This can be a tricky process. If you need some help, we’ve provided
a ‘How To’ article on our website, (www.chiefproducts.com.au/blogs/
how-to/11555201-wk2-lower-front-fascia-removal-installation).
3
Disconnect Fender Flares
1. Pull the wheel well lining from under the fender
towards the inside.
2. Push the (3) plastic tab style clips from the inside to
release the front of the fender.
3. Pinch the (2) plastic clips above the wheel from the
inside.
4. Do this for both sides (driver & passenger).
NOTE: Not required for SRT & Summit style Bumper Fascia.
4
Remove Plastic Fasteners from Engine Bay
1. Using a flat head screw-driver, remove (2) plastic push
fasteners.
