WK2 OFF-ROAD FRONT BUMPER
INSTALL INSTRUCTIONS
TABLE OF CONTENTS
REVISION B
29 AUGUST 2022
PAGE of
8
40
INSTALLATION START
REQUIRED TOOLS
NOTES
Tape Measure
Felt Tip Marking Pen
Tape
Utility Knife
Punch Tool
1/2” (3/8”) Drive Ratchet
10mm Socket
16mm Socket
10mm Combination Spanner
16mm Combination Spanner
H4 Hex Key
Ruler (150mm Minimum)
Small reciprocating Saw (Saber Saw)
Smooth Files, Small (Flat & Round)
Screwdriver (flat blade)
1/2” (3/8”) Drive Extension
13mm Socket
18mm Socket
13mm Combination Spanner
18mm Combination Spanner
H8 Hex Key
• Left and Right are defined from the drivers perspective.
• All fasteners to be installed using supplied “Anti-Seize” for best
performance.
• Do not over-tighten fasteners.
• Photos are representative only. They may show prototype parts and
be taken from multiple vehicles.
IMPORTANT
• PROPER INSTALLATION IS ESSENTIAL TO THE PERFORMANCE OF THIS PRODUCT.
• ONLY INSTALL THIS PRODUCT ON A 2011-2021 JEEP GRAND CHEROKEE.
• ONLY USE THE PROVIDED HARDWARE FOR INSTALLATION.
• DO NOT MODIFY THE STRUCTURE OF THIS PRODUCT IN ANY WAY.
• CHECK PRODUCT REGULARLY FOR DAMAGE. REPLACE IMMEDIATELY AT FIRST SIGN OF DAMAGE.
• CHECK FASTENER TIGHTNESS REGULARLY AND TIGHTEN IF REQUIRED.
HELPFUL TIPS
• Final tightening of fasteners is best done af
t
er fitting all the components into place and gradually
tightening to achieve the best fit.
• Use of the supplied anti-seize will prevent fasteners from becoming seized and ensure ease of
disassembly in future.
• Due to the modular nature of the WK2 O
ff
-Road Front Bumper, the installation steps vary
accordingly. Pay attention to the prompts in the blue boxes for guidance.
• It is recommended a second person assist when handling the vehicle Bumper Fascia and/or the
ORFB.
