WK2 OFF-ROAD FRONT BUMPER
INSTALL INSTRUCTIONS
TABLE OF CONTENTS
REVISION B
29 AUGUST 2022
PAGE
of
13
40
16
Remove OEM Wiring Loom Plastic Bracket
1. Remove (2) M5 bolts.
2. Remove OEM Wiring Loom Plastic Bracket and set
aside.
NOTE: Not on all vehicles.
17
Remove OEM Steel Bumper
1. Remove (2) M8 Flanged Nuts (Blue Circle) from Air
Compressor and set aside for later (if applicable).
2. Remove (1) M6 Bolt from each side (Blue Square).
3. Remove (3) M8 Bolts from each side (Red Circles).
4. Remove (2) M8 Bolts from bonnet struts
(Red Squares).
5. Remove (2) Push Plastic Fasteners (Yellow Circle)
from plastic parts on side, and set aside for use later.
6. Remove OEM Steel Bumper and set aside.
18
Remove OEM Wiring Loom Bar
1. Disconnect all clips from wiring loom bar.
2. Remove (1) M6 Bolt from each side (Blue Square).
3. Remove (1) M8 Bolt from each side (Red Circle).
4. Remove OEM Wiring Loom bar.
IF YOU HAVE A WINCH with:
• WK2 RECOVERY POINT-HOOK
(Go To Step 19)
• No WK2 RECOVERY POINT-HOOK
(Go to Step 20)
IF NON WINCH
(Go to Step 36)
19
WINCH + WK2 RECOVERY POINT-HOOK
Install Chassis Support Plates
1. Place (1) Top Plate [D] on top of (1) Chassis
Strengthening Plate [B] on top of the WK2 Recovery
Hook/Point mounting plates.
2. Holding the entire stack together, place it against the
frame and install (finger-tight), re-using your WK2
Recovery Hook/Point install bolts, (M10 x 90mm Bolts
& Wedge-Lock Washers).
3. Do this for both sides (passenger & driver).
NOTE: Install Strengthening Bolt with Head Facing Downward .