Chicago Pneumatic TR 630, Инструкция по безопасности и эксплуатации

Страница: 26 / 36

Cleaning the machine
♦
Do not spray water directly onto electrical
components or the instrument panel.
♦
Place a plastic bag over the fuel filler cap and
secure with a rubber band. (This will prevent
water from entering the venting hole in the filler
cap. Otherwise this could cause operational
disturbances, such as clogged filters.)
After the first 20 hours of
operation
Maintenance routines:
♦ Check the engine spacer bolts.
♦
Change the engine oil and replace the oil filter.
See the engine manual for more information.
♦
Check and adjust engine valve clearances. See the
engine manual for more information.
Inspection of engine spacer bolts
Check that the engine spacer bolts (A) are properly
tightened.
A
Diesel engine, changing the oil and filter
Only drain the engine oil while engine is warm.
1. Unscrew the drain plug (A) on the draining hose
and drain off all the oil. Use a container with at
least a 2.5 litre capacity.
A
2. Replace the drain plug (A) and tighten.
3. Loosen the oil filter (B) by using a band wrench.
B
4. Clean the surfaces (C) carefully.
C
D
5. Replace the oil filter (D) and tighten by hand.
6. Fill with engine oil.
7. Run a for a short time to make sure that the oil
filter is oil tight. If necessary tighten.
After the first 150 hours of
operation
Maintenance routines:
♦
Change the hydraulic oil filter.
9800 1262 01a | Original instructions 26
TR 630, 850 Safety and operating instructions