Chicago Pneumatic TR 630, Инструкция по безопасности и эксплуатации

Страница: 15 / 36

Installation
Fuel
Filling
WARNING Fuel hazard
The fuel is extremely flammable and fuel fumes can
explode when ignited, causing serious injury or
death.
►
Protect your skin from contact with the fuel.
►
Never remove the filler cap or fill the fuel tank
when the machine is hot.
►
Never smoke when filling the fuel tank or when
working with the machine or servicing it.
►
Avoid spilling fuel and wipe off any fuel spilled
on the machine.
Filling procedure
1. Stop the engine and let it cool down before
filling the tank.
2. Release the filler cap slowly to let any pressure
escape.
3. Fill the fuel tank to the lower edge of the filler
pipe.
4. Never overfill the tank. Due to the movement of
the fuel within the tank, it is possible to have fuel
at a higher level than the tank cap, which can
lead to a spillage of fuel if the tank cap is opened.
This can be avoided by only opening the tank
cap when the machine is on level ground and
the tank cap is at the fuel tank's highest point.
Operation
WARNING Engine running hazard
Vibrations from the engine can cause material
changes, this can cause the machine to move and
cause injuries.
►
Never leave the machine with the engine running.
►
Ensure that only authorized personnel operate
the machine.
► Never give the transmitter to anyone who is not
fully familiar with the machine, its operation and
safety directives.
WARNING Transmitter hazard
If the operator is not fully familiar with the control
system when operating the machine, this may lead
to sudden and unexpected movements of the
machine which can cause injuries.
► Always study this safety and operating instructions
carefully before operating the machine.
►
Only trained personnel who are fully familiar with
the control system may operate the machine.
NOTICE When operating the machine, follow the
instructions in the manual; never sit or stand on the
machine when it is working.
NOTICE Do not operate the machine at a greater
distance than 20 metres (22 yards). Always keep the
working area and the machine under good
supervision.
NOTICE Always specify the serial number when
making inquiries about control equipment.
Transmitter
The transmitter and receiver must have the same
address code and serial number. If another
transmitter is used, it must be coded so that the
address code corresponds with the receiver. See
section "Pairing function" for more information.
Coding must be performed by authorized service
personnel.
The range is up to 30 metres (33 yards), depending
on the surroundings and the occurence of any radio
frequency interference.
15 9800 1262 01a | Original instructions
Safety and operating instructions TR 630, 850