Chicago Pneumatic TR 630, Инструкция по безопасности и эксплуатации

Страница: 16 / 36

♦
Two 1500 mAh NiMh batteries are supplied with
the machine on delivery. The extra battery can be
charged in the battery charger during operation.
♦
Insert the battery (A) into the transmitter by
sliding it into the slot until it is in locked position.
To remove the battery, twist the lock on the
transmitter.
A
♦
The operating time for a fully-charged battery is
about 15 hours. The transmitter has a yellow LED
that lights for 10 seconds when it is time to charge
the battery. In this mode, the battery can be used
for another 15 minutes. Change the battery and
make sure that the slot and contact surfaces are
clean.
♦
The extra battery can be charged in the receiver
on the machine during operation. The battery
charger is mounted on the front of the electrical
box, under the rear service hatch. Before charging
the battery, make sure that the battery charger's
and battery's contact surfaces are clean and dry.
♦
Radio communication is interrupted when the
battery is removed from the transmitter.
♦
The transmitter can be used without the battery
if it is connected to the machine with the supplied
cable.
♦
The battery must be trickle-charged every four
weeks, if the transmitter is not used. Remove the
battery if the transmitter is not used for a long
period.
Status Indication LED
Battery discharged. Constant yellow light for 10
seconds.
Battery low charge. Flashing yellow light.
Joystick in wrong position when
starting the machine. Green and red light.
No connection. Fast flashing green light.
Normal operation mode. Slow flashing green light.
Internal fault, transmitter. Constant red light for 10
seconds.
Receiver
The receiver (A) is mounted in the electrical box
under the rear service hatch.
A
For radio or general indication, a LED labelled RX is
used.
Status Indication on RX
No connection. Constant green light.
The receiver is connected.
Safety relay (RCSS) is ON. Fast flashing green light.
The receiver is connected.
Safety relay (RCSS) is OFF. Slow flashing green light.
Internal fault, RX (receiver). Constant red light.
Internal fault, TX (transmitter). Fast flashing red light.
Pairing function
The receiver and transmitter have a pairing function
so that a transmitter can be paired with the receiver.
The receiver learns the transmitter ID. Since
BlueTooth is used for communication, the BlueTooth
client in the transmitter is paired with the BlueTooth
server in the receiver.
9800 1262 01a | Original instructions 16
TR 630, 850 Safety and operating instructions