Chicago Pneumatic TR 630, Инструкция по безопасности и эксплуатации

Страница: 19 / 36

1. Check the engine oil level.
2. Fill the fuel tank with fuel.
3. Check that all the controls are working.
4. Make sure that there is no oil leakage, and that
all bolted joints are tightened.
WARNING Sudden machine movement
hazard
During the starting procedure when the hydraulic
system is connected, the machine may move in
either direction. If the machine moves, it may be
sudden and this movement that can cause injuries.
►
Keep your feet away from the machine.
►
Pay attention and look at what you are doing.
NOTICE Always store the transmitter securely to
prevent unauthorized starting of the machine.
NOTICE Any use of a start gas can shorten the life
of the engine. Never use start gas.
NOTICE During operation oil leaks can occur and
bolted joints can come loose, this can cause engine
breakdown.
NOTICE If the engine fails to start, wait for 3
seconds before a new attempt to start. If the starter
motor is used for more than 20 seconds, a delay is
activated for 8 seconds.
NOTICE If the charging symbol and oil pressure
symbol do not extinguish, the machine must be shut
off. Fault tracing and repair must be performed by
authorized service personnel before the machine is
started again.
Starting the engine, Hatz
1. Open the rear service hatch and pick up the
transmitter. Insert and turn the battery
disconnector (A) to locked mode. The buzzer (B)
sounds when the power is switched on. The
buzzer stops when the engine starts.
A
B
C
2. Close the service cover and pull out the
emergency knob (C) on the machine.
3. Release the start/stop button (D) on the
transmitter. The LED will flash slowly with a
green light during normal operation.
D
E
F
G
H
4. Press the horn button (E) until contact is
established between the transmitter and receiver.
5. Set the switch for engine speed (F) to low.
6. Start the engine with the toggle switch (G),
release when the engine has started.
7. Check the battery status. The low-battery
warning light (H) must not light. Always have
an extra fully-charged battery available.
8. Check the oil pressure.
The flashing warning light (A) mounted on the hood
is activated when the battery disconnector and
emergency stop are activated.
19 9800 1262 01a | Original instructions
Safety and operating instructions TR 630, 850