Check Point IP690 - Flash Based Sys, Руководство по установке

Страница: 66 / 118

6
Installing, Using, and Replacing ADP Services Modules
66 Check Point IP690 Security Platform Installation Guide
„
Push the transceiver into an available port in the ADP module.
„
Rotate the transceiver latch lever down to secure the transceiver in the ADP module.
Note
Depending on the design of your transceiver, you might need to rotate the latch lever
upward to release the device.
„
Insert an appropriate interface cable into the transceiver.
„
To remove an ADP transceiver:
„
Remove the cable.
„
Release the transceiver by rotating the latch lever.
„
Pull out the transceiver.
Note that if you install any ADP transceivers that are not supported by Check Point, they are not
recognized by IPSO; the system rejects the transceivers and includes them in a list of rejected
interfaces on the Interface Configuration page in Check Point Network Voyager, as shown in the
following figure.
Note
The Non-Supported SFP Components table appears only if you have ADP transceivers
installed that are not supported by Check Point.
Check Point ADP Module LED Reference Information
All Check Point IP690 ADP modules provide a single LED for each port. The LED illuminates
solid green for Link status and blinks green to indicate Activity.