Check Point IP690 - Flash Based Sys, Руководство по установке

Страница: 58 / 118

6
Installing, Using, and Replacing ADP Services Modules
58 Check Point IP690 Security Platform Installation Guide
Note
Check Point supports only ADP modules and transceivers sold by Check Point. For further
information, contact your Check Point representative.
Installing and Replacing ADP Modules
Note
Before you begin this procedure, you should review all ADP module information in the
Getting Started Guide and Release Notes for the version of IPSO you are using and refer to
both of these documents as needed as you complete the installation and configuration
process.
Use these instructions to install an ADP module in your appliance.
Before You Begin
To install a Check Point ADP module, you need the following:
„
A Phillips-head screwdriver
„
Physical access to the appliance
„
Access to the appliance by using Check Point Network Voyager or the CLI
„
A suitable, grounded work surface
„
The ADP module kit
Note
You do not need to manually disconnect power for this procedure. Any servicing of the
appliance, however, should be completed with the chassis tray assembly fully removed from
the appliance.
To install an ADP module in IP690 appliances
1.
You cannot preserve the configuration for slot 2 of your appliance when you replace your
PMC NICs with an ADP module or, conversely, when you replace your ADP module with