Check Point IP690 - Flash Based Sys, Руководство по установке

Страница: 50 / 118

5
Connecting PMC Network Interface Cards
50 Check Point IP690 Security Platform Installation Guide
Figure 13 Ethernet Crossover-Cable Pin Connections
Two-Port and Four-Port Copper Gigabit Ethernet NIC
The Check Point IP690 security platform supports Check Point-approved, four-port and
two-port copper Gigabit Ethernet NICs installed on a PMC expansion slot. The IP690 can
accommodate up to four Gigabit Ethernet NICs.
When you purchase a copper Gigabit Ethernet NIC with your IP690, the NIC is installed before
the appliance is delivered to you. For information about how to add or replace a NIC, see
Chapter 4, “Installing and Replacing Network Interface Cards.”
Copper Gigabit Ethernet NIC Features in the IP690
The copper Gigabit Ethernet NIC supports:
„
Tracing through tcpdump
„
High bandwidth
„
Full-duplex mode operation up to 1 Gbps
„
Link speed auto advertising (10/100/1000)
„
PCI operation at 133 MHz on the IP690
„
Compliance with IEEE 802.3ab Gigabit Ethernet specifications
You can configure and monitor Gigabit Ethernet NIC interfaces with Check Point Network
Voyager. Specifically, you can use Network Voyager to set the port speed and full-duplex mode
to 1000, 100, or 10 Mbps.
For information about how to access Network Voyager and the related reference materials, see
“Using Check Point Network Voyager” on page 38.
00017.1
1
2
3
4
5
6
7
8 1
2
3
4
5
6
7
8