WARNING
8
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner
controls OFF, wait 5 minutes and repeat the lighting
procedure. If the burner does not ignite with the valve
open, gas will continue to flow out of the burner and could
accidently ignite with risk of injury.
Turn controls and gas source or tank OFF when not
in use.
Main Burner Match-Lighting
Do not lean over grill while lighting.
1. Open lid during lighting.
2. Place match into match holder (hanging from side of cart).
Light match, place into lighting hole on right or left side of
firebox.
3. Push in and turn far right or far left knob to position. Be
sure burner lights and stays lit.
4. If ignition does not occur in 5 seconds, turn the burner control
knob
OFF
, wait 5 minutes, and repeat the lighting procedure.
5. Light other burners by pushing knob in and turning to
position.
Warning:
Top cover must be open
when side burner(s) is in
operation.
Side Burner Ignitor Lighting
Do not lean over grill while lighting.
1. Turn
OFF
all Gas Burner Control Valves.
2. Turn
ON
gas source or tank.
3. To ignite side burner, open side burner cover.
4. Turn side burner knob to , to ignite burner.
5. Once burner has ignited, turn knob to desired setting.
6. If side burner does not light, turn knob to OFF, wait 5
minutes, and repeat the lighting procedure.
Side Burner Match-Lighting
1. Open lid during lighting. Turn on
gas at LP cylinder.
2. Place lit match near burner.
3. Turn side burner knob to .
Burner Flame Check
Remove cooking grates and troughs. Light burners, rotate knobs
from to . You should see a bigger flame in
position than seen on . Perform burner flame check on side
burner, also. Always check flame prior to each use. If only low
flame is seen refer to “Sudden drop or low flame” in the
Troubleshooting Section
of your grill manual.
Turning Grill Off
Turn all knobs to
OFF
position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
Ignitor Check
Turn Gas OFF at LP cylinder. Press and hold electronic ignitor
button. “Click” should be heard and spark seen each time
between collector box or burner and electrode. See
“Troubleshooting”
in your grill manual if no click or spark
.
Valve Check
IMPORTANT: Make sure gas is OFF at LP cylinder before
checking valves.
Knobs lock in
OFF
position. To check valves,
first push in knobs and release, knobs should spring back. If
knobs do not spring back, replace valve assembly before using
grill. Turn knobs to
LOW
position then turn back to
OFF
position.
Valves should turn smoothly.
Hose Check
Before each use, check to see if hoses are cut or worn. Replace
damaged hoses before using grill. Use only valve/hose/regulator
specified by manufacturer.
General Grill Cleaning
Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory
(and should never be painted)
. Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush on
insides of grill lid and bottom. Rinse and allow to completely air
dry.
Do not apply a caustic grill/oven cleaner to painted
surfaces.
Plastic parts:
Wash with warm soapy water and wipe dry. Do
not use citrisol, abrasive cleaners, degreasers or a concentrated
grill cleaner on plastic parts. Damage to and failure of parts can
result.
Porcelain surfaces:
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use non-abrasive scouring powder
of stubborn stains.
Painted surfaces:
Wash with mild detergent or non-abrasive
cleaner and warm soapy water. Wipe dry with a soft non-
abrasive cloth.
Stainless steel surfaces:
To maintain your grill’s high quality
appearance, wash with mild detergent and warm soapy water
and wipe dry with a soft cloth after each use. Baker-on grease
deposits may require the use of an abrasive plastic cleaning pad.
Use only in direction of brushed finish to avoid damage. Do not
use abrasive pad on areas with graphics.
Cooking surfaces: If a bristle brush is used to clean any of the
grill cooking surfaces, ensure no loose bristles remain on
cooking surfaces prior to grilling. It is not recommended to clean
cooking surfaces while grill is hot.
