Firebox
Burners shown in place
.
Replace Main Burner Bezels and Control Knobs
NOTE: REPLACE ONE BEZEL AT A TIME. DO NOT REMOVE ALL THE BEZELS AT THE SAME TIME.
- Pull the Tube Burner Control Knobs off of Valve Stems.
- Remove screws and washers that secure each Bezel to the Control Panel. Save removed Bezels for converting back to LP Tank Gas.
- Install new Natural Gas Bezels provided with Kit (see illustration below) in place of old Bezels onto Control Panel, and secure using previously
removed screws and washers. Assure proper alignment with control knob before fully tightening.
Note: New bezels will change the rotation
for the control knob to properly control ignition and flames for your grill.
- Press Control Knobs back onto Valve Stems. Make adjustments needed to Bezels for free movement of Control Knobs.
10
Main Burner
Control Knobs
Bezels
Valve
Stem
Screws
Main Burner Conversion (Cont.)
NOTE: Replace only one
bezel at a time!
I
nstall Burner
Attachment
Screws
(4 per burner)
Reinstall Burners
- Place all burner assemblies into place in the firebox, align the burner assembly screw holes with the mating holes in the firebox.
- Carefully insert the #8x3/8” screws through the burner assembly and into the firebox. Insert 4 screws per burner assembly.
- Using a #2 Phillips screwdriver, not provided, barely tighten each screw. DO NOT over-tighten the burner attachment screws. These screws
are used to hold the burner in place. Overtightening will cause problems later when attempting to clean your grill.
9
NOTE:
Do not over-tighten
the burner
attachment
screws.
17
Natural Gas Bezel
80007876
