- Remove the ignitor wire from the electrode. Shown in view “A”
- Remove the two burner mounting screws and washers from the side shelf pan. Shown in view “B”
- Lift up the burner to disengage the stud from it’s locating hole and maneuver the burner out of the side shelf pan. Shown in view “C”
NOTE: The convoluted gas tubing is flexible and will allow sufficient clearance to complete this conversion.
DO NOT twist or crimp the
Convoluted (flexible) Gas Tubing. To do so may result in gas leakage
6
Remove Ignitor
wire from
Electrode
5mm Silicone
Washer
#10 Lock Washer
#10-24x3/8” Screws
Locating Stud
A
B
C
Electrode
Remove Burner
from side burner pan
- Locate the Sideburner Venturi underneath the sideburner shelf. The Sideburner Venturi will be suspended by the convoluted gas tubing.
Carefully position the Sideburner Venturi so that you can access the Orifice Holder Bracket screws
- Using a Phillips Screwdriver, remove two #5-40 screws from the Orifice Holder Bracket. Save these screws for reassembly later.
- After removing the #5-40 screws, CAREFULLY pull Orifice Holder Bracket away from the Sideburner Venturi as shown in detail #1.
NOTE: The convoluted gas tubing is flexible and will allow sufficient clearance to complete this conversion.
DO NOT twist or crimp the
Convoluted (flexible) Gas Tubing. To do so may result in gas leakage.
6
Detail #1
Convoluted (Flexible)
Gas Tubing
Sideburner
Venturi
Orifice
Holder
Bracket
Orifice
#5-40
Screws
Orifice
Holder
Bracket
Sideburner
Valve
View from below sideburner shelf.
Sideburner
Venturi
Convoluted (Flexible)
Gas Tubing
16
17
Sideburner Conversion (Cont.)
21
