24
FINE TUNE THE FORCE
The REVERSAL FORCE DIAL on the control board is used for fine tuning
the force in cases where wind or environmental changes may affect the
gate travel.
Based on the length and weight of the gate it may be necessary to make
additional force adjustments. The force setting should be high enough
that the gate will not reverse by itself nor cause nuisance interruptions,
but low enough to prevent serious injury to a person. The force setting is
the same for both the open and close gate directions.
1. Open and close the gate with the test buttons.
2. If the gate stops or reverses before reaching the fully open or closed
position, increase the force by turning the force control slightly
clockwise.
3. Perform the “Obstruction Test” after every force setting adjustment
(see below).
ADJUST THE LIMITS
After both limits are set and the operator is ready to run, one limit can be
adjusted independently from the other by following steps 1-3 of the Initial
Limit and Force Adjustment section, on page 23.
ADJUSTMENT
LIMIT AND FORCE ADJUSTMENT continued...
DIAGNOSTICS
DIAGNOSTICS
DIAGN
OPEN limit
CLOSE limit
DIAGNOSTICS
2
3
1
OBSTRUCTION TEST
The operator is equipped with an automatic obstruction sensing feature.
If the gate encounters an obstruction during motion, the operator will
automatically reverse direction of the gate for a short time and then stop
the gate. After any adjustments are made, test the operator:
1. Open and close the gate with the test buttons, ensuring that the gate
is stopping at the proper open and close limit positions.
2. Place a solid object between the open gate and a rigid structure.
Ensure that the gate, the solid object, and the rigid structure can
withstand the forces generated during this obstruction test.
3. Run the gate in the close direction. The gate should stop and reverse
upon contact with the solid object. If the gate does not reverse off
the solid object, reduce the force setting by turning the force control
slightly counter-clockwise. The gate should have enough force to
reach both the open and close limits, but MUST reverse after contact
with a solid object.
4. Repeat the test for the open direction.
