CD Automation Revo M 2PH, Руководство пользователя

Страница: 10 / 45

CD Automation srl REVO M User’s Manual
CD-Eng-REVO-M-2PH-30-40A-Thyristors-Units
10
6 Quick Start
Attention: this procedure must be carried out by skilled people only.
If your REVO M code is in line with what you really need, then the main configuration is already done by
CD Automation and you just need to do the following steps:
1. Verify REVO M’s current sizing. Be sure that:
 the load current is equal or less than the nominal one of REVO M
 the main voltage is equal or less than the nominal voltage of REVO M
2. Verify the Installation
3. Verify the Wiring:
 all auxiliary connections must be done in line with wirings on this manual
 verify that there isn’t a short circuit on the load
4. Supply the auxiliary voltage of the unit
Set the parameters U_OP (Operative Voltage) and A_Lo (Nominal Current of the load) using the
frontal keypad or CDA Thyristor configurator software.

Operative Voltage V R/W
Function: It’s necessary to specify the operative voltage
Min/Max: 24 ÷ 1000V
Default: 230
Note: With voltage up to 330V and over 600V, REVO M needs hardware
modifications: specify this in phase of ordination.

Load nominal current A R/W
Function: It’s necessary to specify the load current value at nominal voltage.
This current and voltage value are necessary to be able to read the
power in engineering units
Min/Max: 1 ÷ 100.0 Ampere (for size up to 100A)
Default: Nominal REVO M current value if load current has not been specified.
If your REVO M code is NOT in line with what you really need, use the enclosed configurator
software tool to set-up the unit. Install the software on your PC, select REVO M and click on
test unit changing what you need.