89
The wireless LAN connection between the Data Projector and computer
keeps dropping.
This can be caused by the following.
• Data communication can slow down and the connection may tend to drop when the
Data Projector and computer are far from each other (in different rooms, on different
floors, etc.) Move the Data Projector and computer as close together as possible.
• Operation of a device that uses the 2.4 GHz frequency band (which is the same
frequency band as the IEEE802.11b wireless standard used by the Data Projector) in the
vicinity of the Data Projector can cause radio interference that results in a wireless
communication error. Avoid using the nearby microwave oven or Bluetooth device when
performing Data Projector wireless LAN communication.
After checking the above two points, select [Exit] on the [Connection] menu of the Wireless
Connection window to exit Wireless Connection, and then restart Wireless Connection.
You cannot display the Web Setup page
The Web Setup page can be displayed only while there is a wireless LAN connection
between the Data Projector and computer. Use a Simple Connection or Manual Connection
to establish a wireless connection between the Data Projector and computer, and then
display the Web Setup page. For more information, see
If the Web Setup page does not appear even through there is a wireless LAN connection
between the Data Projector and computer, check the following points.
• The Web Setup of the Data Projector may be disabled. Use the procedure under “To
enable and disable Web Setup” (page 67) to check the current setting. If it is “Disable”,
change it to “Enable”.
• The browser you are using may be configured to use a proxy server. This can make it
impossible to display the Web Setup page, and so the proxy server settings should be
canceled. See the help and other user documentation for your browser for information
about proxy server settings.