Casio KL-G2TC, Руководство пользователя

Страница: 24 / 73

22 EN
■
Four cut modes
The printer has four cut modes.
x
To specify a cut mode, perform step 5 under "Printing a Label" (page 20).
x
Note that the cut method and margin length depends on the margin
settings.
x
Regardless of the currently selected cut mode, full cutting and half cutting
are never performed while
邊距 不留 (Margins None) is specifi ed for the
print format (page 30).
x
Tape cutting is not performed when the tape length is one of those shown in
the table below. In this case, you can use scissors or some other implement
to cut the tape after printing is complete.
邊距 小
(Margins Narrow)
邊距 中
(Margins Medium)
邊距 大
(Margins Wide)
Approximately 28mm
or less Approximately 35mm
or less Approximately 44mm
or less
■
通常 (Normal)
x
通常 (Normal) performs a half cut between labels, and a full cut when the
end of the printing is reached.
■
切斷
(Cut)
x
切斷 (Cut) perform a full cut at the end of each label, and a half cut near the
beginning of each label to make the backing paper easier to remove.
■
特殊 (Special Tape)
x
特殊 (Special Tape) performs a full cut at the end of each label.
x
When using the 小 (Narrow) and 中 (Medium) margin settings, this setting
automatically performs a full cut to trim off excess tape.
■
不裁切 (Uncut)
x
When 不裁切 (Uncut) is selected, the printer does not perform any cut
operation between labels.
x
This setting is best when you want to print labels without spaces between
them, which saves label tape.
x
After printing is complete, press 功能 and then to feed the tape, and
then cut it with a pair of scissors.