Case CX130C, Руководство оператора

Страница: 259 / 282

9 - ACCESSORIES
Usage of a hydraulic crusher
1. Operate the controls of boom, arm and bucket in order
to install the hydraulic crusher to the bucket linkage at
the top of the arm.
2. Stop the engine. Set the starter key to ON position,
and press the right-hand auxiliary pedal to release
pressure inside the auxiliary high-flow hydraulic circuit.
3. Close the feed valves at the top of the arm. Install
the connecting hoses between the attachment and the
feed valves. Then reopen the feed valves.
VOHLGR-016
9
4. Start the engine. Press and hold the attachment se-
lector button (1) for 1 s to get directly to the dedicated
tab for operational settings of the auxiliary high-flow
hydraulic circuit.
5. Select CRUSHER as attachment type, and set the
proper flow rate of the circuit.
NOTICE: The working pressure of the multifunction
auxiliary high-flow hydraulic circuit shall be set man-
ually by the relief valve located behind the boom foot.
6. Press the menu button (2) to confirm the selection.
SMIL18CEX0768AB
10
7. Resume the operating mode of the display. An icon
on the top-right of the display indicates the type of
attachment (crusher) and the storing number (1 to 5)
of the flow rate currently in use.
The pump setting (single or twin) and the value of max-
imum flow rate are shown at the top-center of the dis-
play.
NOTICE: to prevent failure or damage to the tool,
make sure that you select the correct circuit configu-
ration and flow rate and pressure for the tool.
SMIL18CEX0558AA
11
Alternative display layout in case of rear view camera in-
stalled.
SMIL18CEX0559AA
12
9-5