CAS LP-2G, Руководство по обслуживанию

Страница: 43 / 104

10 Printer Hardware Settings
35
< CAL: PRINTER SENSOR CALIBRATION >
The Printer will calibrate sensors
and print threshold values.
Press any key when ready.
GAP= 100 PEEL= 151
< CAL: PRINTER SENSOR CALIBRATION >
The Printer will calibrate sensors
and print threshold values.
GAP= 102 PEEL= 150
ADJUST GAP SENSOR THRESHOLD
1. Decrease 3. Increase
2. Decrease 5 4. Increase 5
THRESHOLD= 200
USE FEED KEY TO TEST
ADJUST PEEL SENSOR THRESHOLD
1. Decrease 3. Increase
2. Decrease 5 4. Increase 5
THRESHOLD= 125
The printer will then feed
out several labels and then print
the threshold values.
Once the threshold values
are printed they will also appear
on the top left corner of the
screen temporarily. Finally, the
screen will return to the Printer
Sensors menu.
10.2.2 Gap Sensor Fine Adjust
At the Printer Sensors
Menu screen, press the 2 key for
Fine Gap Adjust. You will see the
following screen:
Pressing the 1 key will
decrease the value by 1; the 2 will
decrease it by 5. Pressing the 3
key will increase the value by 1;
the 4 will increase it by 5.
Press the FEED key to the test alignment or press the SAVE key to save the changes.
10.2.3 Peel Sensor Fine Adjust
At the Printer Sensors
Menu screen, press the 3 key for
Fine Peel Adjust. You will see the
following screen:
Pressing the 1 key will
decrease the value by 1; the 2
will decrease it by 5. Pressing the
3 key will increase the value by 1;
the 4 will increase it by 5.
You can press the FEED key to test the status of the sensor: if there is a label waiting to be taken
then it will read BLOCKED; if you remove the label it will read UNBLOCKED. When finished, you can press
the SAVE key to save the changes.