CAS LP-2G, Руководство по обслуживанию

Страница: 40 / 104

9 Digital Filtering
32
Are you sure? (Y/N)
NUMERIC
< SELECT COUNTRY >
Select Number : [0]
0. Default
1. USA 2. RUSSIA
3. TURKEY 4. EUROPE
Static RAM: This is where all of your PLU sales data & the scale’s Runtime environment are stored.
Erasing this memory will loose all PLU sales data.
EEPROM: This is where all of your CAL mode settings & calibration data are stored. Erasing this memory
will require complete reprogramming of ALL CAL mode options and then SPAN calibration of the scale
( must be done in that order. ) NOTE: This will have no effect on the Audit Trail Counters; there is no way
of resetting the Audit Trail Counters.
All Memory: As the title implies, this option will erase ALL 3 memories & thus you will be faced with the
above 3 ramifications.
Selecting any of the 4
options will bring you to the
following screen:
Once you press Y, there is
no turning back. Some memories
will take longer than others to
clear; however, the maximum
time to clear ALL the memories is
approximately 60 seconds. Some
of the clearing processes will report memory chip numbers or memory sizes during the process.
WARNING: If you clear the memory you will loose ALL data in that respective part of memory!
NOTE: You can also clear All Memory by the following procedure:
1. Make sure that the Main Power is OFF (switch on left side of scale.)
2. Press and hold down the C key on the upper left corner of the keyboard.
3. While you are holding down the C key, turn the Main power ON.
4. Once you here a “chirp” release the C key.
5. After a few seconds the scale will clear all memory & set up default USA settings.
8.7 Select country
You can select country, and then
EEPROM is initialized.