Carver 356 2004, Руководство пользователя

Страница: 190 / 225

S
ECTION
8 W
INTERIZATION AND
S
TORAGE
181
3937 3/99
19. Position the aft head overboard discharge selector
valve to "OVERBOARD".
20. Below the boat, place a large bucket beneath the aft
overboard discharge fitting to collect antifreeze
pumped out later in this procedure. This fitting is
located beneath the aft hatch in the aft stateroom
floor.
21. Flush 5 gallons of antifreeze through the aft head.
Continue flushing the head until a steady stream of
antifreeze flows from the overboard discharge
fitting.
22. Close the aft overboard discharge fitting.
23. Position the forward head overboard discharge
selector valve to "OVERBOARD".
24. Below the boat, place a large bucket beneath the
forward overboard discharge fitting to collect anti-
freeze pumped out later in this procedure. This
fitting is located below the galley floor hatch.
25. Flush 5 gallons of antifreeze through the forward
head. Continue flushing the head until a steady
stream of antifreeze flows from the overboard
discharge fitting.
26. Close the forward overboard discharge valve.
27. When you remove your boat from storage and
prepare to use it again, flush and pump the waste
tanks to remove the antifreeze.
Wash the exterior of the boat, particularly the underwa-
ter portions. Remove as much aquatic growth as pos-
sible while it is still wet. Once the growth has dried it is
more difficult to remove.
Check the zinc sacrificial anodes for deterioration. If the
zincs shows signs of deterioration have them replaced
before spring launch. Check stainless steel rails and
fittings for signs of rust. Remove rust prior to winter
lay-up. Inspect the underwater portions of the hull.
Review anything that looks out of the ordinary with
your Carver Dealer.
Exterior