Carver 356 2004, Руководство пользователя

Страница: 77 / 225

AC E
LECTRICAL
S
YSTEM
S
ECTION
3
68
3937 2/99
Test each GFCI receptacle once every week:
1. Press the Test button. If the GFCI is operating
normally, this cuts the power supply to the GFCI
receptacle and to all other receptacles on that
circuit.
If the GFCI receptacle or any other receptacle on that
circuit still has power after the Test button is
pressed, do not use any of the receptacles on that
circuit. Contact a qualified electrician to make the
appropriate repairs.
2. Plug a lamp or other AC powered device into the
GFCI receptacle and turn on the device. The device
should not operate.
3. Repeat Step 2 for each receptacle on the same
circuit as the GFCI receptacle.
4. Press the Reset button to restore power to the GFCI
receptacle and to all other receptacles on that
circuit.
When operating AC powered devices through your
boat’s AC electrical system, be aware that each device
exerts a “load” on the system. This load is equal to the
amount of current (amps) that the device draws from
the AC electrical system. The AC electrical system, like
your house’s electrical system, has a maximum total
load that it can handle. The Line 1 and Line 2 (if in-
stalled) circuits each have an electrical load capacity of
30 amps.
If the total load on the circuit exceeds the circuit’s
capacity, the breaker for that circuit trips. This means
that the devices operating from the circuit are drawing
too much current.
Do not overload the electrical circuits. If an excessive
load trips a circuit breaker, turn off all devices con-
nected to the circuit, then switch the breaker back
"ON".
Electrical Loads