Carver 356 2004, Руководство пользователя

Страница: 110 / 225

S
ECTION
4 I
NTERNAL
S
YSTEMS
101
3937 2/99
Never obstruct quick access to the propane stove system
components and shut-off valves. Keep valves on empty
propane tanks closed and disconnected.
Keep protective covers, caps or plugs in place. Store
reserve or empty tanks on open decks or in gas-tight
lockers that vent overboard and are intended for storing
propane tanks. Do not use the propane tank box for
storing any other equipment.
Never leave your boat unattended when the propane
stove is in use. Do not smoke or use an open flame while
replacing propane tanks. Hoses in the propane stove
system must be inspected regularly, at least annually,
and replaced if any deterioration is found. Inspect the
flue pipes, at least annually, and replace them if any
deterioration, cracks or openings are found.
Never use flame to check your propane stove system
for leaks.
The propane stove system is inspected and pressure
checked as part of Carver’s quality assurance process.
We do, however, suggest that you test the system for
leaks regularly. Use the following system inspection
process every time you remove and reinstall the pro-
pane tank. The following information has been taken
from the Seaward Products Owner’s Manual For Gas-
Operated Stoves.
1. After the propane tank has been installed, the
regulator system connected, the hose run and
connected to both the stove and regulator, slowly
open the propane tank valve until the propane is
flowing. The pressure gauge on the regulation
system should read approximately 110 psi at 70
degrees F. (the pressure is higher if the air around
you is warmer; lower if the air is cooler).
2. Close the propane tank valve and observe the
pressure gauge. It should hold a constant reading
over a 15-minute period. If the gauge reading
decreases over that time, there is a leak in the
system.
Checking the
System For Leaks