Carver 356 2004, Руководство пользователя, Страница: 130 / 225

S
ECTION
5 P
ROPULSION
121
3937 3/99
Switch "ON" any other circuit breakers for equip-
ment you may need.
6. On the Bridge Breaker Panel, switch the Main
circuit breaker "ON", then switch the Bilge Blower
circuit breakers "ON".
Switch "ON" any other circuit breakers for equip-
ment you may need (horn, trim tabs, Halon, etc.).
7. Turn "ON" the bilge blowers using the controls on
the helm instrument panel.
8. Check the output level of the bilge ventilator. You
can feel air being blown from the output bilge vent
if the bilge blower is operating properly.
9. Verify that all safety gear is onboard and in proper
operating condition. Check items such as the navi-
gation lights, VHF radio, depth sounder, etc. Make
sure your boat carries all safety equipment re-
quired by Federal, State and local regulations.
10. Verify that you have an adequate supply of fresh
water.
11. Check the level of waste in the waste tanks. Empty
them if necessary. Refer to the "Emptying the
Waste Tanks" portion of Section 4 .
12. Disconnect and store the shore power cord and
shore water hose.
Starting the Engines
Always run the bilge blowers for at least 4 minutes
before starting the boat’s engines or the generator.
1. Open the cooling system seacocks for both engines.
2. Move both shift levers to neutral.
3. Select the engine you wish to start first. NEVER
start both engines at the same time.