Model 702G/O Advanced gas/oil burners — Instruction manual
Carlin part number MN702GO Rev. 06/23/14
– 26 –
Where appliance instructions differ from this manual, follow the appliance instructions.
Step 7
(firing on oil and on gas)
Verify operation
Burner/appliance/controls operation
❏
Test operating and limit controls on appliance as specified in appliance instruc-
tions.
❏
Check operation of the primary control by forcing lockout to occur. For primary
controls that enter latch-up after multiple lockouts, force latch-up to occur as
well. Reset primary control per control data sheet instructions after each test.
❏
Start and stop the burner several times, allowing the primary control to sequence
through normal operation. Verify correct operation of burner and primary control
throughout on both oil and gas.
❏
Confirm and/or adjust overfire combustion pressure for oil and gas operation.
Refer to boiler/furnace manufacturer’s recommendations.
Verify vent system operation
❏
Verify vent is operating correctly and flue products are properly exhausted from
building. If the building contains any exhaust fans or conditions that could affect
vent performance, check burner/appliance/vent operation with exhaust fans (or
other conditions) operating.
Combustion/ventilation air
❏
Verify combustion/ventilation air openings are not, and will not be obstructed.
❏
Verify air opening louvers are fully open.
❏
If louvers are motor-operated, verify motor and end switch are interlocked with
appliance/burner wiring to prevent operation of the burner if the air louvers are
not fully opened.
Prepare burner for normal operation
❏
Cycle burner off with appliance controls.
❏
Turn off power to the appliance.
❏
Seal the appliance flue test opening.
❏
Verify all components and wires are in place and burner is ready for operation.
❏
Restore power to the appliance.
Train the user
❏
Train the user to operate the burner and appliance under normal conditions.
❏
Explain the procedure to shut down the burner/appliance when required.
❏
Review the back cover of this manual (and the appliance manual) with the user.
❏
Verify the user is aware of all procedures specified in the manuals.
❏
Verify that the user will not store or use combustible liquids or materials or
contaminants in the vicinity of the burner/appliance.
