Cantek C12RSH, Руководство по эксплуатации

Страница: 32 / 37

SRS-12H MANUAL Chapter 5: MAINTENANCE & REPLACEMENT
27
oil discharge
screw point
Covering screw
of the oil filler
oil le vel windo w
Adjusting
threaded rod
Fix nut
* Changing the oil for the feed chain reduction gears:
After 300 working hours, the inside of the feed chain speed-reducer should be
cleaned and the oil for the gears should be changed. Thereafter, the gear oil should
be changed for every 2500 working hours. When changing the oil, take off the
“covering screw of the oil filler point” at first, and then turn on the “oil discharge
screw”. After all the old oil has drained out, turn the “oil discharge screw” tight
again. Add proper lubricant to the oil inlet until it rises above the oil level window.
(In order to maintain the operation life of the machine, it is important to choose the
good quality of grease.We suggest using the grease offered by the machine
manufacturer or its agents.)
Add SAE 90# lubricating oil to the “oil filler point” until it rises above the “oil
level window”.
5-3 ADJUST AND REPLACE SAW ARBOR BELT
The drive belts of the machine will surely happen the loosening situation after an
extended operation and then influence work efficiency. In order to minimize
wearing of the belts and the loss of machine's power, the belts should be re-tightened
by increasing an appropriate distance between the saw arbor pulley and the motor
pulley.
The distance between the saw arbor pulley and the motor pulley is adjusted by a
“threaded rod” (using an adjustable spanner or 26mm open-end wrench as tools).
Before adjusting or changing the belts, loosen the “lock nut” by turning clockwise.
Then, the threaded rod can be turned until the desired position is reached (to loosen
by turning clockwise; to tighten by turning counter-clockwise). After finish the
adjustment, the “lock nut” must be tightened again by turning it counter-clockwise.