Cantek C12RSH, Руководство по эксплуатации

Страница: 29 / 37

SRS-12H MANUAL Chapter 5: MAINTENANCE & REPLACEMENT
24
Feed chai n
lubricating in lets
Clean brush
CHAPTER 5:
MAINTENANCE & REPLACEMENT
Must disconnect the power supply from the machine before doing any maintenance
or replacement. The operator must obey the following rules to avoid any serious
injury.
5-1 CLEANING
Regularly clean all machine parts and the surrounding environment can help a safer
operation and prolong the machine life. The correct procedures for cleaning your
machine are:
◎
Regularly remove sawdust from the feed chain by using a compressed-air gun,
because the sawdust on the feed chain will suck lubricant. If the feed chain
slide on guide track without enough lubricant, it will cause serious wear on
feed chain. The operator must clean up the sawdust on every chain block
completely.
◎
Open “feed chain safety cover”, you can see clearly there are one clean-brush
and three (3) lubrication inlets for feed chain. They are the important
components to protect and prolong the lifespans of feed chain and track.
Never let sawdust be accumulated on the clean-brush and lubrication inlets.
Especially the lubrication inlets will be stuck with sawdust easily and make
the lubricant can not fall on the feed chain. In case the feed chain and track
are not lubricated properly for a period of time, these two expensive parts will
be worn away very quickly.