Cantek C12RSH, Руководство по эксплуатации

Страница: 23 / 37

SRS-12H MANUAL Chapter 3: Operation
18
Fence sca le
Fix
Rele ase
3-6 ADJUSTING THE POSITION OF RIP FENCE
The Fence is positioned with a clamp handle, to fix it by pushing the handle forward,
to release it by pulling the handle backward in order to move the fence. The
distance between fence and sawblade can be read by the sideline. There must be a
distance between fence and sawblade while handling edge-trimming. The width of
this distance depends on how neat of the edge of workpiece. It needs more distance
between them if the edge of workpiece is more irregular.
3-7 FEEDING
◎
In order to obtain a precise straight-line ripping, the four sides of workpiece
should be better in the same thickness. Also, the workpiece can not be bent
or deformed too much, and its thickness can not be over 85mm.
◎
In order the pressure rollers can hold the workpiece fully, the length of
workpiece can not be shorter than 200mm.
◎
Put the workpiece on the worktable and against the fence, then feed it
between feed chain and pressure rollers to begin sawing. The operator
MUST let go of the workpiece as soon as it has been pushed into the machine.
Even if the workpiece does not enter into the machine straightly, the operator
should NEVER attempt to straighten it with his hands.
◎
Check the profiles of the workpiece after sawed, to find out if the feeding
speed is proper or not. If not, please adjust the machine to the optimum
feeding speed according to the paragraph
3-5.