background image

Manual

tapo-fix CB 75 N

Working Width 82 cm

tapo-fix CB 1000 N

Working Width 106 cm

1. Set up the Pasting Machine

1b. Slide the slipshell across the 
hinge.

1c. Unfold the left leg.

1d. 

 

Slide the slipshell across the 

hinge and raise up the machine.

1a. Release the locking on the  
frame. Unfold the right leg. 

2. Align

Put the Pasting Machine CB 75 N or CB 1000 N in front of the
Equipment Table. Align and determine the castors. Mount the Table- 
Widening at the Equipment Table 70 F. If working with Equipment Table
75 N or 1000 N align and determine the castors.
When available, mount the Sliding cutter and the CB Counter.

3. Fill in paste

Mix paste according to the manufacturer's instructions. 
(If possible, use special paste for Pasting Machines)
Fill the paste tray up to 2cm below the edge.

4. Adjust paste thickness

Adjust the thickness of the paste with the adjustment knobs on both sides. 
Set 1 for thin wallpapers, accordingly more paste for thicker 
wallpapers. After adjusting the thickness tigthen the fixing screw in the  
knob. 

Important: Do not expose the paste roll to direct sunlight or heat. 
Clean only with cold water.

5. Fit in the wallpaper

Slide the wallpaper rod though the roll and fix it in the middle with the
stop discs, then hang it in the holder. 

Locking

Accessories (not included): CB Counter, Sliding cutter 75-800, Table-Widening, 
Equipment Table 70 F

Accessories (not included): CB Counter, Sliding cutter 75-800

Accessories (not included): CB Counter, Sliding cutter 75-800

knob

fixing screw

Отзывы: