H1000
Page 4 of 45
Installation Manual
Oct 2015 • Rev. 2.6
Expansion board for ease of future system upgrades
Compatibility with CP40 controller (limited)
Supports 65,000 users
Supports 2 readers/doors
Supports Entry/Exit per reader/door (Exit readers are
Hurricane Software Supported)
Supports 26-bit or Cansec 37-bit Wiegand and the
HID Corporate 1000 format
Supports 8 Input points (with or without supervision)
Supports 8 Output relays
Supports Direct Integrated Keypads (with encryption)
Supports 16 to 64 floors elevator control (see “H1000
Elevator Control Installation Guide” document)
Introduction
Cansec Systems’ H1000 control panel utilizes a 32-bit processor and implements
new system architecture. This new architecture allows for easy system upgrades
without the need for H1000 control panel replacement. Included in the new
H1000 architecture is the ability to ‘Flash’ applications and firmware updates into
the control panel using the existing host communication connection port.
The H1000 control panel is ‘flashed with CP40 emulation code’ and thus supports
up to 65,000 users. In the CP40 mode emulation, and using Hurricane software,
the H1000 control panel supports two door combinations where each door may
have an Entry and an Exit reader. The readers can be Cansec’s CanProx One
Proximity Readers (AWID or HID card technology) or one of many other popular
Wiegand readers.
The H1000 control panel has provisions to support industry-standard 26-bit
Wiegand, Cansec 37-bit Wiegand or the HID Corporate 1000 format. The H1000
control panel board supports 8 on-board inputs (supervised or non-supervised), and
8 on-board Form “C” relay outputs. Standard firmware supports elevator control.
Key Features
Note:
Always ensure the H1000
controller is operating on the latest
approved firmware version for
compatibility to this document.
EX100 - Expansion Board
H1000 Control Panel
