H1000
Page 14 of 45
Installation Manual
Oct 2015 • Rev. 2.6
READER STATUS LEDS
RLED1 through RLED8 are used to indicate the reader status of the associated
reader ports (RD1-RD8). When a valid Wiegand format credential is presented
to the reader, the LED flashes RED to indicate that the credential has been
read. A non-valid Wiegand format will cause the LED to flash multiple times
(Please see the “Troubleshooting” section for a table of RLED’s error indicator).
When the H1000 is powered on, RLED1 & RLED3 will be on solid RED.
These are the 2 active reader ports in the CP40 mode emulation:
RD1=CP40 Reader A
RD3=CP40 Reader B
Note:
Exit Reader RD2 & RD4 are supported when using Hurriane software.
Figure 4: Reader Status LEDs
