H1000
Page 32 of 45
Installation Manual
Oct 2015 • Rev. 2.6
INPUT POINT WIRING (NON-SUPERVISED)
NOTE:
Jumpers SH9, SH11, SH13 and SH15 must be set to the bottom 2 pins to
enable input mode for those points (factory default).
NOTE:
There are no jumpers on points 10, 12, 14 and 16.
If supervision is not required, the Cansec end-of-line resistor will not be used.
You must disable supervision at the dip switch
(S2)
by setting switch 2 (OPT2)
to ON as shown.
Figure 21: Wiring Input Points (Non-supervised)
