Canon iR6570 series, Руководство по обслуживанию

Страница: 75 / 684

Chapter 2
2-17
<Manual Feed Tray>
1) Move the side plates [1] to the center. Loosen the 2 mounting screws
[2] of the manual feed tray, and adjust the position of the manual feed
tray.
F-2-57
<Duplexing Feeder Unit>
1) Select the following service mode COPIER > ADJUST > FEED-ADJ
> ADJ-REFE, and make an adjustment so that margin on the 2nd side
image will be within specs.
F-2-58
2.2.19 Adjusting Leading Edge Registration
0008-8559
1) Select the following service mode COPIER > ADJUST > FEED-ADJ
> REGIST, and make an adjustment so that margin will be within
specs.
F-2-59
2.2.20 Getting the Machine Ready for Installation
0008-8111
<Storing the drum rotation tool and grip>
1) Remove the 2 screws, and detach the right rear bottom cover; store
the parts below.
1. Drum rotation tool [1]: Store it inside the waste toner case cap in the
hole of the drawer grip at the top of the waste toner case [2].
2. Grip (included in the package): Store it in the grip storage area [3].
F-2-60
The drum rotation tool and the cap cannot be stored if the drawer grip is
fully drawn out. Therefore, draw out the grip in moderation as shown the
fig. below.
F-2-61
2) Attach the right rear bottom cover with the 2 screws.
<Attaching the grip cover>
1) Attach the grip cover (small) [1] to the latch blanking cover [2].
F-2-62
2) Attach the 3 grip covers (large) [1] and the cover [2] assembled in step
1) to the machine.
[1]
2.5+/-2.0mm
Increase the value of
ADJ-REFE
(Margin is increased by
1mm with increase of 10) Decrease the value of
ADJ-REFE
(Margin is decreased by
1mm with decrease of 10)
0
2
4
6
8
10
0
2
4
6
8
10
Paper leading edge
Decrease the value of REGIST
(Margin is increased by 1mm with decrease of 10)
Increase the value of REGIST
(Margin is decreased by 1mm with increase of 10)
[1]
[2]
[3]
[1] [2]