Canon imageRUNNER ADVANCE 525 I, Руководство по обслуживанию

Страница: 489 / 651

COPIER (Service mode for printer) > OPTION (Specification setting mode) > FEED-SW
TFL-RTC 1 Set delvry dest at rcvry after tray full
Detail To select the delivery destination for a job with multiple pages after recovering the Delivery Tray
that reaches the full level.
When 0 is set, a job is output from the delivery destination again from which the last job was
delivered.
When 1 is set, a job is output from the delivery destination which priority is set as high at "Output
Tray Settings" in [Settings/Registration].
Use Case When changing the delivery tray
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Output from the tray from which the last job was output, 1: Output from the delivery destination
which priority is high among the delivery trays
Default Value 0
Additional Functions
Mode
Function Settings> Common> Paper Output Settings> Output Tray Settings
SP-SW 1 Disable static elimination control
Detail To set the value to 1 to change the static eliminator bias value to 0V.
Use Case When white spots are generated on thin/moist paper in high humidity environment due to excessive
static elimination bias
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Display/Adj/Set Range 0 to 1
0: Static elimination bias ON, 1: static elimination bias OFF
Default Value 0
■ IMG-RDR
COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-RDR
DFDST-L1 1 Adj dust detect level: ppr intvl, DADF
Detail To adjust dust detection level with dust detection correction control that is executed at paper
interval in DADF mode.
Reduce the value in the case of frequent display of cleaning instruction at the time of dust detection.
As the value is smaller, the dust is less detected.
Increase the value when black lines appear. As the value is larger, the small dust is more likely
detected.
Use Case - When black line occurs due to dust
- Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution When increasing the value too much, the cleaning instruction screen may appear too often since
even small dust that will not be appeared on the image can be detected.
When decreasing the value too much, black lines may appear.
Display/Adj/Set Range 1 to 255
Default Value 200
Related Service Mode COPIER> OPTION> IMG-RDR> DFDST-L2
Supplement/Memo
Black lines may appear on the image if there is dust. With dust detection correction control, the
image is corrected to prevent black lines once dust is detected.
8. Service Mode
479