35
Error Messages
Excessive temperature or
humidity.
The temperature or humidity where
the printer is installed is out of the
acceptable range for operation.
Press
▲
or
▼
to select
Stop
, and then press the
OK
button to stop printing.
Press
▲
or
▼
to select
Continue
, and then press the
OK
button to continue with color calibration. However,
note that correct adjustment may not be possible.
Calibration There is a problem
with the multi-sensor.
The performance of a sensor
inside the printer may be impaired.
Press the
OK
button and cancel calibration. Contact
your Canon dealer for assistance.
Use the printer under suitable environmental
conditions. Also note that various environmental
conditions are recommended for various types of
paper. For details on the recommended environmental
conditions, see the Paper Reference Guide
.
Error Message
Cause
Corrective Action
Cannot calibrate.
The paper for printing a test
pattern is soiled. Otherwise, you
have loaded colored paper.
Press the
OK
button to clear the error.
Load unused paper compatible with color calibration.
End of paper feed.
You are pressing the
▲
button on
the
Control Panel
and trying to
rewind the roll to the edge.
Release the
▲
button.
(
→
"Types of Paper," User's Guide)
(
→
"Types of Paper," User's Guide)
The test pattern was printed too
faintly.
Press the
OK
button to clear the error.
Direct sunlight or strong lighting
may be shining on the printer and
causing the sensor to malfunction.
Press the
OK
button to clear the error.
Take steps to remedy faint printing.
(
→
, Troubleshooting)
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Cannot execute this command.
Use other paper.
Paper compatible with color
calibration is not loaded.
Insufficient paper for job
The printer has received
a print job longer than the
amount of roll paper left when
ManageRemainRoll
in the
Control Panel
menu is
On
.
Press
▲
or
▼
to select
, and then press the
OK
button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of the
document.
Press
▲
or
▼
to select
Change Paper
, and then
press the
OK
button.
Change the
Paper Source
of the printer driver, or
replace the roll with a roll that has enough paper for
the print job, and then print.
(
→
, Removing the Roll from the Printer)
(
→
, Loading Rolls in the Printer)
Press the
OK
button to clear the error.
Load paper that is compatible with color calibration.
See the Paper Reference Guide
.
(
→
"Types of Paper," User's Guide)
Always make sure the loaded paper matches the
type of paper in the printer paper settings. Adjustment
cannot be completed correctly unless the loaded
paper matches the settings.
1.
2.
Press
▲
or
▼
and select
Stop Printing
or press the
Stop
button to stop printing.
Please execute calibration.
There is not even one color
calibration execution result.
Execute color calibration.
This is displayed when paper is
loaded in the printer and
Prompt
Execution
is set to
On
on the
Control Panel
menu.
(
→
"Using Color Calibration for Color Adjustment,"
User's Guide)
Set
Prompt Execution
to
Off
on the
Control Panel
menu.
(
→
, Menu Map)
Содержание imagePROGRAF iPF6300S
Страница 51: ......
