Chapter 2: System hardware
System Components
Page 2-14
Table 18 AP/BHM LED descriptions
LED
Color when active
Status information
provided
Notes
PWR Red
DC
power
Always lit after 10-20 seconds of power
on.
SYN/1 Yellow
Presence
of
sync -
SES/2 Green
Unused
-
GPS/3 Red
Pulse
of
sync
Lit when the AP/BHM is getting a sync
pulse from a GPS source goes along
with SYN/1
ACT/4 Yellow
Presence of data
activity on the
Ethernet link
Flashes during data transfer. Frequency
of flash is not a diagnostic indication.
LNK/5
For 450i and 450m
Series
Red/ Green/Orange
(bi-colored for
10/100/1000)
Ethernet link
Ethernet link
Continuously lit when link is present.
10Base-T : Red
100Base-T : Green
1000Base-T : Orange
For 450 Series
Green
Continuously lit when link is present.
SM/BHS LEDs
The SM/BHS LEDs provide different status of radio based on the operating modes. A SM/BHS in
“operating” mode registers and passes traffic normally. A SM/BHS in “aiming” mode does not
register or pass the traffic, but displays (via LED panel) the strength of received radio signals
(based on radio channel selected via Tools -> Alignment).
Содержание PMP 450d Series
